Is it possible to detect rx+ rx- tx+ tx- wires with multimeter?

Is it possible to detect rx+ rx- tx+ tx- wires of an ethernet cable having only a part of cable with multimeter or somehow else?

I mean the situation when you have just one side of the ethernet cable. The other side is connected to a working switch or hub far away. And the guy that did the other side of the cable didn't use standard wiring (green and orange pairs).

I am talking about 100mbit cables, not 1000mbit.

Call someone at the far away place and have them read out the color order to you. Or walk over there. The max length of the cable is 100m...not that much exercise.

Or better yet, cut that jack off and wire it properly.

If the pairs are in the wrong order the cable can still work, but will confuse the next guy. If they were not wired with pairs in the right places, you wont have "twisted pairs". That is essential for proper transmission, especially on longer runs.

A multimeter wont do you much good. A cable tester will. My fluke cable tester will try to establish a connection to the device on the other end on different combinations of pairs and report which ones worked.