How can I check and change the partition table type?

Solution 1:

What is a partition table? How is it related to Windows 8?

In addition to general partitioning, it should be noted that information about partitions are stored in a partition table on the hard disk.

The whole topic didn't receive much attention because DOS/Windows computers – where one would install Linux onto – just had one choice for almost three decades. ^{(MBR was introduced in 1983.)} Until Windows 8 finally replaced the long overdue and outdated BIOS/MBR subsystem combination with UEFI/GPT. ^{(Comparison of GPT and MBR on the Arch Wiki.)}

While GPT is the name for the new format, there is some confusion about how to name the old one as MBR previously described the bootloader code that is stored along the partition information in the partition table.

How do I check and change the partition table?

Read these instructions carefully before you start!

Also note that you can convert partition tables: How can I change/convert a Ubuntu MBR drive to a GPT, and make Ubuntu boot from EFI?

1. GUI-method - Using GParted

   To find out what partition table type the selected drive has select View > Device Information from the menu.

   

   Select the disk of which you want to change the partition, then select Device > Create Partition Table from the menu.

   

   If you get a warning that the device contains active partitions, unmount these. Note that you cannot unmount partitions of your currently running operating system. You will then see the window below, where you can choose the partition table type. msdos is what GParted calls the old format, gpt the newer one. All the others for other operating systems or architectures.

   Please also note the warning message. Creating a new partition table will discard all information about existing partitions on the disk. It will not overwrite data on the partitions, but you still don't want to have to dig through and restore data afterwards. Therefore consider the old partitions gone and all data lost after you created the new partition table and backup your data before doing so.

   

2. CLI-method - Using parted

   To display partition table information run:

   sudo parted --list
   

   To create a new partition table run:

   # This is a destructive action that will destroy all data on the partitions of the device
   sudo parted device mklabel label-type
   

   device should be replaced with the device name (e.g. /dev/sdb) and label-type with msdos or gpt.

   You can also run parted interactively by just running sudo parted. More details in the manpage.