How to change NSString value while debugging in Xcode?

Solution 1:

You can do this in the debug console. Say you have NSString* myVar. In the console, after (gdb), type set myVar = @"My new string". If you are using (lldb), then use the equivalent expression expr myVar = @"My new string" instead.

This may not show up correctly in the variables panel, but you can verify the value by entering po myVar into the console. Your code should pick up the new value.

For some great info about using expr, check out this StackOverflow post.

Solution 2:

You can but you have to call code from the debugger command prompt. For example, say you have a breakpoint fire off right after this line:

NSString *myString = @"My current string";

Then at the (gdb) prompt type:

call myString = @"My new string"

You can po myString before changing the string and after you change it to verify that it has changed.

Another example: Say you wanted to change a view controller's title. You can use the setter. *Note: dot notation is not supported at the debugger command line. For example let the view load and then set a breakpoint somewhere during the lifetime of your view controller. Then do this: