"Could not get any response" response when using postman with subdomain

First Go to Settings in Postman:

  1. Off the SSL certificate verification in General Tab:

  1. Off the Global Proxy Configuration and Use System Proxy in Proxy Tab:

  1. Make Request Timeout to 0 (Zero)

Configure Apache:

If above changes resulted in 404 response, then continue reading ;-)

Users that host their site locally (like with XAMP and/or WAMP), may be able to visit their virtual-sites using https:// prefixed address, but it's a lie, and to really enable SSL (for each virtual-site), configure Apache like:

  • Open httpd-vhosts.conf file (from Apache's conf/extras directory), in your preferred text-editor.

  • Change virtual-site's settings, into something like:

    <VirtualHost *:80 *:443>
        ServerName my-site.local
        ServerAlias *.my-site.local
        DocumentRoot "C:\xampp\htdocs\my-project\public"
    
        SSLEngine on
        SSLCertificateFile "path/to/my-generated.cert"
        SSLCertificateKeyFile "path/to/my-generated.key"
    
        SetEnv APPLICATION_ENV "development"
    
        <Directory "C:\xampp\htdocs\my-project\public">
            Options Indexes FollowSymLinks
            AllowOverride All
            Order allow,deny
            Allow from all
        </Directory>
    </VirtualHost>
    

    But of course, generate a dummy-SSL-certificate, and change all file-paths, like from "path/to/my-generated.cert" into real file-addresses.

  • Finally, test by visiting local-site in browser, but using http:// (without S) prefixed address; Apache should now give error like:

    Bad Request
    
    Your browser sent a request that this server could not understand.
    Reason: You're speaking plain HTTP to an SSL-enabled server port.
    Instead use the HTTPS scheme to access this URL, please.
    

I had the same issue. It was caused by a newline at the end of the "Authorization" header's value, which I had set manually by copy-pasting the bearer token (which accidentally contained the newline at its end)


If you get a "Could not get any response" message from Postman native apps while sending your request, open Postman Console (View > Show Postman Console), resend the request and check for any error logs in the console.

Thanks to numaanashraf


Hi This issue is resolved for me.

setting ->general -> Requesttimeout in ms = 0