Pinging computers on local network: destination host unreachable

networking

I have two ubuntu computers on a local network and neither one of them can ping each other. Every time I try I get the "destination host unreachable" error message. Both computers are able to access the internet with any problems.

I have a ActionTech v1000h router from Telus. I've been in touch with one of their customer representatives and they said that there should't be any reason why two devices cannot ping each other on the network.

I'm totally at a loss, do any of you guys have any ideas?

Computer 1:

ifconfig -a

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:10084 errors:0 dropped:0 overruns:0 frame:0
          TX packets:10084 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:797420 (797.4 KB)  TX bytes:797420 (797.4 KB)

wlan0     Link encap:Ethernet  HWaddr c4:85:08:77:d3:f5  
          inet addr:192.168.1.77  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::c685:8ff:fe77:d3f5/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:373068 errors:0 dropped:0 overruns:0 frame:0
          TX packets:380158 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:103445020 (103.4 MB)  TX bytes:112630337 (112.6 MB)

route -n

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         192.168.1.254   0.0.0.0         UG    0      0        0 wlan0
169.254.0.0     0.0.0.0         255.255.0.0     U     1000   0        0 wlan0
192.168.1.0     0.0.0.0         255.255.255.0   U     9      0        0 wlan0

sudo iptables -L

Chain INPUT (policy ACCEPT)
target     prot opt source               destination         

Chain FORWARD (policy ACCEPT)
target     prot opt source               destination         

Chain OUTPUT (policy ACCEPT)
target     prot opt source               destination

Computer 2:

ifconfig -a

etho0     Link encap:Ethernet HWaddr 00:24:8c:ae:f6:91
          UP BROADCAST MULTICAST MTU:1500 Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:2
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:110 errors:0 dropped:0 overruns:0 frame:0
          TX packets:110 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:8414 (8.4 KB)  TX bytes:8414 (8.4 KB)

wlan0     Link encap:Ethernet  HWaddr 00:22:43:9b:7b:64  
          inet addr:192.168.1.2  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::222:43ff:fe9b:7b64/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:252 errors:0 dropped:0 overruns:0 frame:0
          TX packets:435 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:123143 (123.1 KB)  TX bytes:65828 (65.8 KB)

route -n

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         192.168.1.254   0.0.0.0         UG    0      0        0 wlan0
192.168.1.0     0.0.0.0         255.255.255.0   U     9      0        0 wlan0

sudo iptables -L

Chain INPUT (policy ACCEPT)
target     prot opt source               destination         

Chain FORWARD (policy ACCEPT)
target     prot opt source               destination         

Chain OUTPUT (policy ACCEPT)
target     prot opt source               destination

Edit: Example of the error when computer 1 tries to ping computer 2:

ping 192.168.1.2

PING 192.168.1.2 (192.168.1.2) 56(84) bytes of data.
From 192.168.1.77 icmp_seq=1 Destination Host Unreachable
From 192.168.1.77 icmp_seq=2 Destination Host Unreachable
From 192.168.1.77 icmp_seq=3 Destination Host Unreachable
From 192.168.1.77 icmp_seq=4 Destination Host Unreachable
From 192.168.1.77 icmp_seq=5 Destination Host Unreachable
From 192.168.1.77 icmp_seq=6 Destination Host Unreachable
^C
--- 192.168.1.2 ping statistics ---
7 packets transmitted, 0 received, +6 errors, 100% packet loss, time 6031ms
pipe 3

Edit 2: arp -a of both computers

Computer 1:

? (192.168.1.254) at 20:76:00:f5:3b:70 [ether] on wlan0

Computer 2:

? (192.168.1.254) at 20:76:00:f5:3b:70 [ether] on wlan0
? (192.168.1.77) at <incomplete> on wlan0

Edit 3: nmap -sn 192.168.1.0/24 on computer 2

Starting Nmap 6.40 ( http://nmap.org ) at 2014-05-07 21:14 PDT
Nmap scan report for 192.168.1.2
Host is up (0.00024s latency).
Nmap done: 256 IP addresses (1 host up) scanned in 3.30 seconds

Edit 4: The tcpdump logs of both computers while the first ping 192.168.1.254 and then each other:

Computer 1:

tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on wlan0, link-type EN10MB (Ethernet), capture size 65535 bytes
22:45:01.661300 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:02.659393 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:03.659394 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:04.676872 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:05.675391 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:06.675396 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:07.692825 ARP, Request who-has 192.168.1.2 tell 192.168.1.77, length 28
22:45:48.379058 ARP, Request who-has 192.168.1.77 tell 192.168.1.254, length 28
22:45:48.379108 ARP, Reply 192.168.1.77 is-at c4:85:08:77:d3:f5, length 28
22:45:54.419388 ARP, Request who-has 192.168.1.254 tell 192.168.1.77, length 28
22:45:54.420875 ARP, Reply 192.168.1.254 is-at 20:76:00:f5:3b:70, length 28

Computer 2:

reading from file pc2.pcap, link-type EN10MB (Ethernet)
22:44:43.538367 ARP, Request who-has 192.168.1.254 tell 192.168.1.2, length 28
22:44:43.676705 ARP, Reply 192.168.1.254 is-at 20:76:00:f5:3b:70 (oui Unknown), length 28
22:45:02.107935 ARP, Request who-has 192.168.1.254 tell 192.168.1.2, length 28
22:45:02.107951 ARP, Reply 192.168.1.254 is-at 20:76:00:f5:3b:70 (oui Unknown), length 28
22:45:06.780619 ARP, Request who-has 192.168.1.77 tell 192.168.1.2, length 28
22:45:07.778419 ARP, Request who-has 192.168.1.77 tell 192.168.1.2, length 28
22:45:08.778419 ARP, Request who-has 192.168.1.77 tell 192.168.1.2, length 28
22:45:09.796214 ARP, Request who-has 192.168.1.77 tell 192.168.1.2, length 28

Edit 5: Setup static ips for both computers etho0 and connected them with an internet cable. Both computers can definitely ping each other through the ethernet cable! ifconfig -a eth0 results:

Computer 1:

eth0      Link encap:Ethernet  HWaddr 68:68:68:00:62:a4  
          inet addr:192.168.1.10  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::6a68:68ff:fe00:62a4/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:15 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:4060 (4.0 KB)  TX bytes:7629 (7.6 KB)

Computer 2:

eth0      Link encap:Ethernet  HWaddr 00:24:8c:ae:f6:91  
          inet addr:192.168.1.20  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::224:8cff:feae:f691/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:250 errors:0 dropped:0 overruns:0 frame:0
          TX packets:130 errors:0 dropped:0 overruns:0 carrier:3
          collisions:0 txqueuelen:1000 
          RX bytes:26501 (26.5 KB)  TX bytes:20897 (20.8 KB)

Solution 1:

ping gateway from both computers ping 192.168.1.254 then try to ping comp1 to compt2 and comp2 to comp1 then post results of arp -a from BOTH boxes

Edit

Interesting, something is blocking traffic

run sudo tcpdump -ni wlan0 arp in one window on both computers and then try pinging each other and the gateway from another window on both again and post results

Edit2

So far that shows that comp1 is doing what it's suppose to sending arp request (asking for comp2s etherner address) but not getting an arp reply (hearing anything back). Need to see the tcpdump from PC2 to see the full picture. Either run the screen command or do this on PC1 sudo tcpdump -w pc1.pcap -ni wlan0 arp & and on PC2 sudo tcpdump -w pc2.pcap -ni wlan0 arp & & should throw it in the background and give you your prompt back for pings. After pings fail bring the jobs back to foreground with fg %1 stop it ctrl+c and read the written files with sudo tcpdump -r pc1/2.pcap

Edit3 PCs are doing what they're suppose to, putting ARPs out but they're not getting through which points to the router. Maybe a disable firewall setting, doubt it supports VLANs? Kinda wish you let it run a bit longer at 22:45:48.379058 your router sent its own ARP request when it was looking for PC1 22:45:48.379058 ARP, Request who-has 192.168.1.77 tell 192.168.1.254, length 28 both PCs should've seen it, we can see that PC1 saw it and replied with its IP but cant tell if PC2 got it since since you stopped it stop just short at 22:45:09.796214. Assuming you're clocks are synced with NTP that is.

Edit4

See that it's still not resolved. Didn't see that you have eth adapters on both PCs. Can you hardwire into the router on eth instead of wlan and see if you can ping then? Or get another router? Or make a hotspot on the phone connect both PCs and try to ping? Also, surprised to see that you were able to connect two PCs together and ping each other did you use a crossover cable?

Solution 2:

Try to connect directly your two computers each other with an ethernet cable, setting to both a fixed IP address (ex A : 192.168.1.10, B : 192.168.1.20) and try to ping again.

Then you will know very quickly if the problem comes from your router, or your computers.

Pinging computers on local network: destination host unreachable

Solution 1:

Solution 2:

Related

Recent Posts