The role of #ifdef and #ifndef

Solution 1:

Text inside an ifdef/endif or ifndef/endif pair will be left in or removed by the pre-processor depending on the condition. ifdef means "if the following is defined" while ifndef means "if the following is not defined".

So:

#define one 0
#ifdef one
    printf("one is defined ");
#endif
#ifndef one
    printf("one is not defined ");
#endif

is equivalent to:

printf("one is defined ");

since one is defined so the ifdef is true and the ifndef is false. It doesn't matter what it's defined as. A similar (better in my opinion) piece of code to that would be:

#define one 0
#ifdef one
    printf("one is defined ");
#else
    printf("one is not defined ");
#endif

since that specifies the intent more clearly in this particular situation.

In your particular case, the text after the ifdef is not removed since one is defined. The text after the ifndef is removed for the same reason. There will need to be two closing endif lines at some point and the first will cause lines to start being included again, as follows:

     #define one 0
+--- #ifdef one
|    printf("one is defined ");     // Everything in here is included.
| +- #ifndef one
| |  printf("one is not defined "); // Everything in here is excluded.
| |  :
| +- #endif
|    :                              // Everything in here is included again.
+--- #endif

Solution 2:

Someone should mention that in the question there is a little trap. #ifdef will only check if the following symbol has been defined via #define or by command line, but its value (its substitution in fact) is irrelevant. You could even write

#define one

precompilers accept that. But if you use #if it's another thing.

#define one 0
#if one
    printf("one evaluates to a truth ");
#endif
#if !one
    printf("one does not evaluate to truth ");
#endif

will give one does not evaluate to truth. The keyword defined allows to get the desired behaviour.

#if defined(one) 

is therefore equivalent to #ifdef

The advantage of the #if construct is to allow a better handling of code paths, try to do something like that with the old #ifdef/#ifndef pair.

#if defined(ORA_PROC) || defined(__GNUC) && __GNUC_VERSION > 300