How can I debug "ImagePullBackOff"?

Solution 1:

You can use the 'describe pod' syntax

For OpenShift use:

oc describe pod <pod-id>  

For vanilla Kubernetes:

kubectl describe pod <pod-id>  

Examine the events of the output. In my case it shows Back-off pulling image unreachableserver/nginx:1.14.22222

In this case the image unreachableserver/nginx:1.14.22222 can not be pulled from the Internet because there is no Docker registry unreachableserver and the image nginx:1.14.22222 does not exist.

NB: If you do not see any events of interest and the pod has been in the 'ImagePullBackOff' status for a while (seems like more than 60 minutes), you need to delete the pod and look at the events from the new pod.

For OpenShift use:

oc delete pod <pod-id>
oc get pods
oc get pod <new-pod-id>

For vanilla Kubernetes:

kubectl delete pod <pod-id>  
kubectl get pods
kubectl get pod <new-pod-id>

Sample output:

  Type     Reason     Age                From               Message
  ----     ------     ----               ----               -------
  Normal   Scheduled  32s                default-scheduler  Successfully assigned rk/nginx-deployment-6c879b5f64-2xrmt to aks-agentpool-x
  Normal   Pulling    17s (x2 over 30s)  kubelet            Pulling image "unreachableserver/nginx:1.14.22222"
  Warning  Failed     16s (x2 over 29s)  kubelet            Failed to pull image "unreachableserver/nginx:1.14.22222": rpc error: code = Unknown desc = Error response from daemon: pull access denied for unreachableserver/nginx, repository does not exist or may require 'docker login': denied: requested access to the resource is denied
  Warning  Failed     16s (x2 over 29s)  kubelet            Error: ErrImagePull
  Normal   BackOff    5s (x2 over 28s)   kubelet            Back-off pulling image "unreachableserver/nginx:1.14.22222"
  Warning  Failed     5s (x2 over 28s)   kubelet            Error: ImagePullBackOff

Additional debugging steps

1. try to pull the docker image and tag manually on your computer
2. Identify the node by doing a 'kubectl/oc get pods -o wide'
3. ssh into the node (if you can) that can not pull the docker image
4. check that the node can resolve the DNS of the docker registry by performing a ping.
5. try to pull the docker image manually on the node
6. If you are using a private registry, check that your secret exists and the secret is correct. Your secret should also be in the same namespace. Thanks swenzel
7. Some registries have firewalls that limit ip address access. The firewall may block the pull
8. Some CIs create deployments with temporary docker secrets. So the secret expires after a few days (You are asking for production failures...)

Solution 2:

I faced a similar situation and it turned out that with the actualisation of Docker Desktop I was signed out. After I signed back in, all worked fine again.

Solution 3:

Try to edit to see what's wrong (I had the wrong image location):

kubectl edit pods arix-3-yjq9w

Or even delete your pod:

kubectl delete arix-3-yjq9w

Solution 4:

I ran into this issue on Google Kubernetes Engine (GKE), and the reason was no credentials for Docker.

Running this resolved it:

gcloud auth configure-docker