Streaming audio from Windows to Linux using PulseAudio

I have Linux box with Ubuntu + PulseAudio network server installed. I can stream audio from my laptop (with Linux installed too) to the box over local network.

I've recently installed Windows 7 into my laptop. I want to stream my laptop audio to the box. Could someone help me setup audio streaming over network over PulseAudio from Windows to Linux box?

Solution 1:

https://github.com/duncanthrax/scream

It took less than 5 minutes to setup. It supports unicast and multicast raw streams from Windows at multiple sample rates. It has listeners for windows, ALSA and pulse-audio.

Solution 2:

The second part of the answer https://superuser.com/a/378000/65570 (the Windows part) probably applies to your case:

either use an old Windows esd driver, or the linco tool.

AFAIU, there is no pulseaudio sound output driver for Windows as of now, nor even the pulseaudio output module for VLC has been ever built for Windows. (This would allow at least an easy way to output the sound from VLC to your remote pulseaudio server.)

Solution 3:

There are many success stories using Jack streaming server.

One of them:

https://blogs.gentoo.org/mgorny/2015/01/16/surround-sound-over-network-with-windows-8/

Solution 4:

I was successful with using JACK, though unlike Eir Nym's answer, the sound is playing from the Linux box as you requested. I did a small write-up of it here: https://gist.github.com/kotarou3/3813bbf7833a0e4618f7fbe8a377872d

The advantage of using JACK over PulseAudio would be lower latency (provided you configure it correctly). Doesn't really matter if you're just playing music, but things like games and recording work needs the low latency.

Partially quoting for posterity:

Stream audio from Windows to Linux

Tested on Ubuntu 16.04 and Windows 10 Redstone 1

Both boxes need to be on the same network (such that multicast packets can be passed between them)

Installing

Linux

1. Setup JACK (easy to do with Cadence)

Windows

1. Install JACK and ASIO Bridge on the Windows box
2. Run regsvr32 32bits\JackRouter.dll and regsvr32 64bits\JackRouter.dll from JACK installation directory
3. Modify 32bits\JackRouter.ini and 64bits\JackRouter.ini to match your channel and sample config
4. (Optional) Set the ASIO Bridge (Hi-Fi Audio) input as the default playback device

Running

1. Start the netjack2 server on Linux with jack_load netmanager (probably also possible to add to .jackdrc for it to autoload)
2. Run JACK NetDriver on Windows (it's in the Start menu), or jackd -R -d net
3. A new device named the hostname of the Windows box should have appeared on the Linux JACK patch panel (Catia if you're using Cadence). Connect it as you see fit (Note: Channels might not match up as expected if you have more than 2).
4. Run ASIO Bridge (also in the Start menu), turn ASIO on, and set the ASIO device to JackRouter
5. The ASIO Bridge should have automatically set up routes to the system device in the Windows JACK patch panel. You can double check with qjackctl (Jack Control in the Start menu) → Connections and connect them if not

Solution 5:

A really simple solution with minimal software is to stream audio using VLC as RTP server and setting up a RTP source in pulseaudio.