How do I wire up my hexipal?

Solution 1:

What you need to do is try a wiring and then place the hexipal in the slot next to the door of the spaceship. Symbols will flash up corresponding to which terminals are connected.

On the back of the Hexipad, each of the symbols corresponds to one of the 6 corners of the hexagon.

In my game, this is which symbol was connected to which corner

A few tips:

1. The wires are color coded. In the symbols that flash up, the symbols are also color coded. As I recall, the top row is blue, middle row is yellow, bottom row is red. These correspond to the rows in the photo.
2. The direction matters. The left of the two symbols is the side you place first when placing the wires.
3. Initially, the wires are always placed in the same order as the symbol rows.

In my game, the code to activate the hexipal was:

1. Blue Wire: Upper-left to lower-right
2. Yellow Wire: Upper-right to lower-left
3. Red Wire: top to bottom

Solution 2:

The photo in Mom's room has the code for the correst wiring: it's the symbols in the left side of the picture. First, connect the wires in any way you like. Then go to Alex' room, and place the Hexipal in the slot near the entrance. Blue, yellow and red symbols will light up. These correspond to the symbols in the pictue, but they're not in the right order. However, they do tell you which point of the hexagon is associated with which symbol. Then all you need to do is make a note of which symbol is where in the hexagon, and you can connect the wires properly.