Is it safe to use a micro-USB 2 cable in a USB 3 portable hard drive?

The micro-B USB 3 port seems to be somewhat backwards compatible with the old micro-USB 2 standard. I was able to charge a phone that had the micro-B USB 3 port with a micro-USB 2 cable.

However, I am not sure to what extent this is a part of the USB standard or just something the phone manufacturer did for backwards compatibility.

I have a hard drive that uses micro-B USB 3. Would it be safe to use the USB 2 standard cable to read/power the hard drive?

ie. Use this cable for this port.

Yes, it's safe. The base connector is identical to the original Micro-B, only adding the USB 3.0 data send/receive lines on the side. (USB 3.0 is backwards-compatible with 2.0, and this applies equally to all connectors it introduced – both the full-size and micro-size, type-A and type-B ports).

The end result will generally be the same as if connecting the drive to a computer's USB 2.0 port (which doesn't have these extra pins, either) – you'll be limited to the speed and power that USB 2.0 allows and won't be able to use UAS, but it should still work properly otherwise.

The extra pins are differential signal pairs (RX+, RX-, TX+, TX-, ground). Compare pinouts for:

• USB 2.0 Type-A/B and 3.0 Type-A/B
• USB 2.0 Micro-A/B and 3.0 Micro-A/B
• The official cable & connector specification is available from USB-IF for free.

Be sure to use a decent cable though, as magnetic disks will probably need the full 500 mA that a USB 2.0 port normally provides. Original phone cables should work fine (modern phones draw several times more anyway), but some cheap replacement cables might be unable to power the HDD at all, or it might repeatedly shut down while in use.

Yes, and no, with a small caveat.

Generally, this will work, and is perfectly safe (albeit considerably slower than using an USB 3 cable).

However, note that some disks require use too much power for USB 2.0 to be sufficient. While the amount of power that you can draw from USB 3 is quite amazing, USB 2.0 is kinda puny in that respect. There are disks which aren't happy with that.

This is still "safe" operation insofar as there is no way you could damage the disk (or the computer) by doing so, but it is not safe insofar as writing data might not be 100% reliable. Actually, it should either work or not work (in particular because spinning up successfully takes the most power), but you cannot be 100% sure. Writing does use more power than idling, and you never know for certain what goes on when a device is slightly under-powered. Generally, though, no worries. Usually it just does work or doesn't, so you can easily tell (all or nothing!), and most modern disks will be in the "just works" camp.

A workaround that is sometimes applied is using a Y-cable which sucks power from two USB 2.0 ports (but only uses one to transmit data). This is strictly a violation of the standard, but it "works fine".
Of course, this is only an applicable solution if you already happen to have one of these lying around (and maybe don't know what they're good for?) because a Y-cable is more expensive to buy than a proper USB 3 cable which will work within the specification and at USB 3 speed...

Yes I can verify this works as I have tested this myself.

I have done this exact same thing with a WD Elements 2TB USB3 portable hard drive and multiple decent quality USB2 micro B cables without problems. But indeed it will be at USB2 speeds.