Why my LibreCAD does not show the design
Here is the console:
$ sudo librecad
RS_DEBUG::setLevel(3)
RS_DEBUG: Critical
RS_DEBUG: Errors
RS_DEBUG: Warnings
QStandardPaths: XDG_RUNTIME_DIR not set, defaulting to '/tmp/runtime-root'
Am I missing any dependency packages?
Solution 1:
Probably because you're extremely far zoomed out, based on the coordinates shown.
Try typing za while in Librecad to zoom all. This should zoom so that the entire outline fits on screen.
Furthermore. DO NOT run Librecad as root. There's no reason to do that.