Can't see A1084 AirPort Express behind A1354 AirPort Extreme

Can anyone please make any suggestions...? (Preferably, step by step instructions to resolve this issue).

I am using AirPort Utility 6.3.2 on a MacBook Pro running MacOS X 10.9.1 Mavericks. AirPort Utility suddenly can't see my two A1084 AirPort Express base stations behind my A1354 AirPort Extreme (which is running Firmware version 7.6.4). The Extreme is behind a CenturyLink Actiontec C1000A DSL modem, which is connected to the Internet.

If I use AirPort Utility set the Extreme to "DHCP and NAT," the utility shows that the Extreme has "Double NAT."

AirPort Extreme set for "DHCP & NAT"

If I set the Extreme to "Bridge Mode," that issue resolves.

AirPort Extreme set for "Bridge Mode"

But, in neither case can I see the AirPort Express base stations.

There is a control to disable NAT in the Actiontec C1000A DSL modem's admin panel, but an attempt to make that change doesn't "take" when I click on "Apply").

Actiontec C1000A control panel for NAT

Because the AirPort Express units are old, only the old AirPort Utility (v5.x) can be used to configure them - but, that old version does not run under Mavericks.

AirPort Utility 5.6 doesn't run under Mavericks


Solution 1:

I cannot comment your post, but at least I have a suggestion: Download a copy of Airport Utility 5.6 working with Mavericks here.

Edit: it seems to me your network is working as always (at least before you began fiddling...:-)), but the thing is you updated Airport Utility to the newest version and therefore cannot see the Expresses? This is a "feature" of the newest Airport Utility.